Onkyo SKF-550F - Manual (Page 60)

60
Advanced Setup —Continued
Equalizer Settings
Here you can adjust the tone of individual speakers. To
set the volume of individual speakers, see page 59.
Notes:
• The front, center, surround, and surround back speak-
ers can be adjusted at Hz, 250 Hz, 800 Hz,
2500 Hz, and 8000 Hz. The subwoofer can be adjusted
at 40 Hz, 80 Hz, and 160 Hz.
• While the Direct or Pure Audio listening mode is
selected, the equalizer settings have no effect.
• This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
1 Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2 Use the Up and Down [ ]/[ ]
buttons to select “Equalizer,” and
then press [ENTER].
3 Use the Left and Right [ ]/[ ]
buttons to select:
Off: Tone off, response flat.
Audyssey: The tone for each speaker
is set automatically by the
Automatic Speaker Setup
function. Be sure to select
this setting after having
performed the Automatic
Speaker Setup.
Manual: You can adjust the equal-
izer for each speaker
manually.
If you selected Manual, continue with
this procedure. If you selected Off or
Audyssey, go to step 7.
4 Press the Down [ ] button, and
then use the Left and Right
[
]/[ ] buttons to select a
speaker.
These settings are set automatically by the Automatic
Speaker Setup function (see page 37).
SETUP
RECEIVER
5 Use the Up and Down [ ]/[ ]
buttons to select a frequency.
Use the Left and Right [
]/[ ]
buttons to adjust the level at that
frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8000 Hz) affect treble sounds.
6 Use the Up [ ] button to select
“Ch,” and then use the Left and
Right [
]/[ ] buttons to select
another speaker.
Repeat steps 5 and 6 for each speaker.
Speakers that you’ve set to No or None
in the Speaker Configuration (page 56)
cannot be selected.
7 Press the [SETUP] button.
The setup menu closes.
SETUP