Optimus CTR-114 - Manual (Page 19)

19
• If you want to record on only one side of a tape,
load the tape so the side you want to record on
faces inside the cassette compartment, set
DIRECTION to REV , then start the recording.
Caution: If you load a cassette with the erase-pro-
tection tabs broken off, do not try to force down
RECORD . This can damage the recording mecha-
nism. (See “Preventing Accidental Erasure” on
Page 29.)
Follow these steps to record.
1. Load a blank cassette tape, or one you want to
record over, into the cassette compartment.
2. Slide MIC SENSITIVITY to LO or HI , depending on
the sound source you want to record.
LO (Low): Select LO when the sound source is
near the recorder.
HI (High): Select HI when the sound source is far
from the recorder, as in a board room, a semi-
nar, or a lecture hall.
14-1120.fm Page 19 Wednesday, January 19, 2000 4:27 PM