beautypg.com

Chapter 2, Getting started, Battery installation – Oregon Scientific Clone Trooper Laptop User Manual

Page 7: Ac/dc adaptor connection

background image

3

Chapter 2

Chapter 2

Getting Started

The

CLONE TROOPER LAPTOP

operates on 3 “AA” size

batteries or a 6V AC/DC adaptor (not included).

Battery Installation

1. Make sure the unit is turned off.
2. Open the battery cover at the back of the unit

using a coin or a straight blade screwdriver.

3. Insert 3 “AA” size batteries.
(Note the correct polarity: +, - ).
4. Replace the cover.

AC/DC Adaptor Connection

Please turn off the unit before plugging in the
AC/DC adaptor to prevent damage to the unit.
Plug the adaptor into the adaptor jack (center
positive type) located on the left hand side of the
unit. Plug the adaptor into a wall outlet.

Caution

• Do not mix different types of batteries or old and new batteries
together.
• Only use batteries of the same or equivalent type as recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be used for

long periods of time.

• Do not dispose of batteries in fi re.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before being

charged.

• Rechargeable batteries are only to be charged under adult supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
• It may contain small parts due to abuse and/ or damage to the unit.
• Not suitable for children under 3 years of age.

Caution

• The unit must not be connected to a power supply greater than 6V.
• Only use the recommended adaptor.
• The adaptor is not a toy.
• Do not short-circuit the supply terminals.
• Toys liable to be cleaned with liquid are to be

disconnected from the power source before cleaning.

• Due to AC/DC adaptor connection, this product is not suitable for

children under 3 years to use without adult supervision.

• Any safety isolating adaptor to be used with the toy should be

regularly examined for potential hazard, such as damage to the cable

or cord, plug, or enclosure of other parts. In the event of such

damage, the toy must not be used until the damage has been

properly

removed.