Ohlins FG 012 - Manual (Page 11)

11
13
Remove the seals and bushings and
check them for wear and damage.
Replace if necessary.
CAUTION!
When removing the oil seal and
bushings use a small plastic bag to
cover the bushing attachment
groove and edges of the inner tube,
to avoid damage to the seals.
14
Fasten the damper rod assembly
with soft jaws in a vice.
Remove all parts from the damper rod.
NOTE!
If the right order is lost, use the
specification card as a guide.
Put them in the right order on the
bench.
Inspect all parts for wear and
damage, replace if necessary.
Clean all parts thoroughly.
Assemble the damper rod.
15
Remove the compression valve
assembly from the fork bottom, use
a 17 mm socket.
Fasten the valve assembly with soft
jaws in a vice.
Remove all parts from the valve
body.
Put them in the right order on the
bench.
Inspect all parts for wear and
damage, replace if necessary.
Clean all parts thoroughly.
Assemble the
compression valve.
Assembling
16
Apply a thin layer of Öhlins green
grease (148-01) on the scraper ring
and on the sealing surface of the fork
seal.
CAUTION!
When installing the oil seal and
bushings use a small plastic bag to
cover the bushing attachment
groove and edges of the inner tube,
to avoid damage to the seals.
Mount the scraper, circlip, fork seal,
support ring and the bushings
separated by the sleeve on the inner
steel leg.
18
Apply some Öhlins green grease on
the seals.
Again, use tool 1799-02 turn it around
to install the seal in the outer leg.
Install the circlip and the scraper.
CAUTION!
Make sure the circlip is fitted
correctly into the groove in the
outer leg.
1799-02
1799-02
16
17
18
17
Fasten the outer leg with soft jaws in
a vice.
Install the inner leg and mount the
upper bushing with tool 1799-02,
and the sleeve.
Mount the lower bushings.