beautypg.com

Using the remote control using the input button, Using the system button, Chapter 2 19 – RCA J32F635 User Manual

Page 19: Inputs and on-screen displays

background image

Chapter 2

19

Using the Remote Control

Using the INPUT Button

In addition to a cable or antenna signal, you might have VCR, DVD etc. or
other signals coming in to your TV (not all inputs are available on all models).
Use the INPUT button to select the desired signal source.

1. Make sure that the component you want to view is turned on.

2. Press INPUT until you have selected the desired input source.

Inputs and On-Screen Displays

The Status Display shows which input signal(s) is selected. The following table
shows which display term usually corresponds with which input.

Input Signal

TV Display

ANTENNA/CABLE jack

(channel digit)

Rear A/V jacks

VID1

Front Jacks

FRNT

Using the SYSTEM Button

When the television is connected to an interactive system or similar device,
the SYSTEM button allows you to access system programming or other special
functionality through the DSCI jack.

On a master or basic remote, the SYSTEM button can also allow independent
remote control of two TVs. Once you have specified TV1 or TV2 status for the
TVs, see the Access and Power Options menu on page 12. Follow these steps
to tell the remote which TV you want to operate:

1. On the remote control, simultaneously press and hold the SYSTEM button

and 1 (for TV1) or 2 (for TV2).

2. After several seconds, release the buttons. The specified TV will respond to

that remote.

3. To control the other TV, simply repeat the process using the other

(1 or 2) button.

INFO

MENU

GUIDE

CLEAR

VOL

CHAN

MUTE

INPUT

RESET

GO

BACK

OK

SLEEP

CCPOWER

SYSTEM

M A S T E R

1

2

3

4

5

6

7

8

9

0

INPUT
button

SYSTEM
button

1 and 2
buttons

Note: Although the TV supports TV3, the
master remote cannot be programmed
for it.

1644105Ae.indb 19

7/18/05 2:27:33 PM

This manual is related to the following products: