RCA D61W17B - Manual (Page 18)

Connections & Setup
16 Chapter 1
Graphics contained within this publication are for representation only.
Connections & Setup
Chapter 1 17
Graphics contained within this publication are for representation only.
Turn on the TV
Press TV on the remote, or press POWER on the TV’s front panel.
Note: Pressing the TV button not only turns on the TV, but puts the
remote into TV mode. “TV mode” means that the buttons on the remote
control operate the TV’s functions.
Complete the Initial Setup
The menu system in your TV allows the TV’s features to work properly. The
first time you turn on your TV, the setup screens appear.
Set the Menu Language
The first part of the setup allows you to select your preferred language for the
menu system.
If English is your preferred language, press OK. If you want to choose another
language, press the down arrow button until that language is highlighted, and
press OK.
Complete Auto Channel Search
The next screen asks you to make sure you've connected the TV to a cable,
satellite, or off-air signal. When you're sure that a signal is connected to your
TV, press OK on your remote to go to the Channel setup screen.
In the Channel setup screen, you can launch the Auto channel search by
pressing OK. The Auto channel search allows the TV to search for all channels
viewable through your antenna or cable TV system. This is sometimes called
auto programming. When the channel search is complete, press OK to access
the List & Labels screen.
Tip
To access the setup menus manually, press
MENU and choose SETUP.