RCA RC 930 - Manual (Page 2)

This symbol is intended to alert you to the presence of uninsulated dangerous voltage
within the system’s enclosure that might be of sufficient magnitude to constitute a risk of
electric shock. Do not open the system’s case.
This symbol is intended to inform you that important operating and maintenance
instructions are included in the literature accompanying the system.
Read and follow precautions when installing and using the Wireless Modem Jack System.
• Read and understand all instructions.
• Follow all warnings and instructions marked on the system and in this guide.
• Unplug this system from the wall outlet before cleaning. Do not use liquid or aerosol cleaners.
Use a damp cloth for cleaning.
• Do not use this system near water; for example, near a bath tub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or in or near a swimming pool.
• This system should never be placed near or over a heat radiator or register. This system should
not be placed in a built-in installation unless proper ventilation is provided.
• This system should only be operated from the type of power source indicated in this guide and on
the system’s label. If you are not sure of the type of power supplied to your home or building,
consult your local power company.
• Never spill liquid of any kind on the system.
• To reduce the risk of electric shock, do not disassemble this system, but take it to a qualified
service facility when service or repair is required.
• Opening or removing the covers might expose you to dangerous voltages or other risks. Incorrect
reassembly can cause electric shock when the system is subsequently used.
• Unplug the system from the wall outlet and refer servicing to a qualified service facility under the
following conditions:
A.
When the AC plug is damaged.
B. If liquid has been spilled into the system.
C. If the system has been exposed to rain or water.
D. If the system does not operate nor mally by following the operating instructions.
E. If the system has been dropped or the cabinet has been damaged.
F. If the system exhibits a distinct change in performance.
• Avoid using a telephone, other than a cordless phone, during an electrical storm. There is a
remote risk of electric shock from lightning.
• Do not use the telephone to report a gas leak in the area of the leak.
FCC Information
We designed your Wireless Modem Jack System to conform to federal regulations and you can connect
it to most phone lines. However, each device you connect directly to the phone line draws power from
it. This power draw is the device’s ringer equivalence number, or REN. The REN is shown on the base
unit’s label.
If you connect more than one phone or other device directly to the phone line, add up all the RENs. If
the total is more than five (or three in rural areas), your phones may not ring. If ringer operation is
impaired, remove a device from the line. Your Wireless Modem Jack utilizes RJ-11 phone connectors.
Note: Your Wireless Modem Jack System has a REN of 0.5B, and so does not affect your phone’s
ability to ring. Also, the phone you plug into the extension unit does not place any load on the telephone
line. However, the phone you plug into the base unit does affect the total REN. If your Wireless Modem
Jack System causes problems on the phone line, the telephone company can disconnect your service.
The phone company tries to notify you in advance. If advance notice is not practical, the telephone
company notifies you as soon as possible and advises you of your right to file a complaint with the FCC.
2
Important Safety Precautions
RC930_IB.QXD 10/10/00 1:12 PM Page 2