RedMax CV225 - Manual (Page 9)

II. How to Assemble Lower Handles
To identify part numbers, see page 8.
1. Use the protective cardboard sleeve to stabilize your
Tiller/Cultivator. Stand the engine assembly up.
2. Lay the handle parts within easy reach. You’ll need the transmission
bracket (#47) and one of the lower handles (#6). Note that the lower
handles have a short leg on one end. (Picture 1)
3. Fit the transmission bracket along the outside of the short leg. Line
up the holes on the clamp and the leg.
4. Using one of the two 3 1/4" bolts (#54), slide it through the hole of
the transmission bracket (#47) and lower handle (#6) closest to the
elbow. (Picture 2) The fit will be tight.
5. Now slide the bolt completely through the second lower handle and
transmission bracket. (Picture 2) Add a nut (#53) and tighten finger
tight.
6. Locate the worm-gear housing. It starts just above — and extends
down through — the Tiller/Cultivator’s red fender. You’ll notice that
there’s a recessed channel on either side of the housing’s top.
7. Take the lower handles that you’ve just put together. Slide them into
the two recessed channels.
Make sure you insert them from the rear of the Tiller/Cultivator
(gasoline tank faces away from the operator) . . . so that the bolt fits
along the back of the housing.
8. Slide the second 3 1/4" bolt through the second hole in the short
legs. Add a nut (#53) and tighten finger tight. (Picture 4)
NOTE: THE NUTS ARE SELF
LOCKING, BUT YOU MUST
USE A WRENCH TO TIGHTEN
THEM COMPLETELY.
Picture 1
Picture 4
Picture 3
Picture 2
9