Rockford Fosgate FFX6 User Manual

Page 7

NSTALLATION

7. Securely mount the amplifier to the vehicle or amp rack. Be careful not to mount the amplifier

on cardboard or plastic panels. Doing so may enable the screws to pull out from the panel due
to road vibration or sudden vehicle stops.

8. Connect the source signal to the amplifier by plugging the RCA cable inputs into the input jacks

at the amplifier.

9. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal and

tighten the set screw to secure into place. Be sure to maintain proper speaker polarity. DO NOT
chassis ground any of the speaker leads as unstable operation may result.

10. Perform a final check of the completed system wiring to ensure that all connections are

accurate. Check all power and ground connections for frayed wires and loose connections
which could cause problems.

NOTE: Follow the diagrams for proper signal polarity.

CAUTION: These amplifiers are not recommended for impedance loads below 2

Ω.

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash or

near the center console, that gives easy
access to the remote.

2. Using the screws supplied, install the

mounting clip with the tabs towards
the back.

3. Route the cable for the remote and

connect to both the remote and
amplifier.

4. Slip the remote onto the mounting clip

until it snaps into place.

5. Install the decal and knob onto the

remote.

Mounting

Clip

Knob

Decal