Rosewill RC-702 - Manual (Page 4)

7.1 Channel PCI Sound Card RC-702 User Manual
3
Physical Connections
The rear panel of this 7.1 Channel PCI Sound Card has the following jacks:
1. Line In (blue) – Connect to tape/CD/DVD player, or other audio sources for output mixing
and/or recording
2. Mic In (pink) – Connect to microphone
3. Front Out (green) - This jack should connect to the powered Left and Right speakers,
located to the left and right of your computer monitor. If you have just a two-speaker
stereo setup, this is the jack to use. You can also plug a pair of stereo headphones into
this jack
4. Rear Out (black) -This line-level output should be connected to powered Left and Right
Surround speakers. These speakers should be located to your left and right sides, just
behind your head
5. Surround Out (black) -The line-level output connects to powered Left and Right Center
Surround channel speakers. These speakers should be located directly you as you are
looking at your computer monitor
6. Center/Subwoofer (orange) -This line-level output connects to powered Center and
Subwoofer speakers. The Center channel speaker should be directly above or below your
monitor and the subwoofer can go just about anywhere it will fit in your room.
7. S/PDIF Out -The Digital Output jack is a S/PDIF Coaxial output
you can use an RCA cable to connect this to a digital recorder, mixer or surround receiver.
A 75 Ohm digital coaxial cable is required for this type of connection