RedMax HC510DV - Manual (Page 12)

Use adequate cutter blades suited to materials
to be cut. Use of inadequate cutter blades may
cause irregular wear of blades, poor cutting
performances, or irregular overheating, etc.
Continuance of those inadequate operations
may damage the blades and cause serious
accidents.
■ CHANGE OF DUST STOPPER
• To apply 12 inch blades, the dust stopper L (on
the engine starter side) shall be exchanged with
an attached 12 inch version before fitting blades.
• In case the dust stopper is unchanged, dust
collection performances become poor.
(1) 14 inch version dust stopper
(2) Screw
(3) Mounting bracket
(a) Remove 14 inch version dust stopper
(b) Fix 12 inch version dust stopper
1. Remove a dust stopper fixed left inside of the
blade cover.
2. Remove a stopper element from a dust stopper
mounting bracket. Properly fix an attached 12
inch version stopper element on the mounting
bracket.
3. Reassemble the dust stopper to the blade cover
as original.
Securely keep the removed dust stopper element
as it is required for 14 inch blade operations.
NOTE
IMPORTANT
WARNING
6. Set up
SE1
12 