Radio Shack CENTRAL 49-2570 User Manual

Page 31

Problem

Solution

The red indicator on the sen-
sor transmitter/motion detec-
tor stays on during installation.

Remove then reinstall the sensor transmitter/motion de-
tector’s batteries. Press

TEST

again.

The ARMED indicator is flash-
ing.

This indicates that there has been an intrusion. Also, if a
zone indicator is on, this indicates which zone was violat-
ed. To turn the zone indicator off and stop the armed in-
dicator from flashing, press the

ARM

DISARM

button on

a remote control. If a zone indicator is not on, the violated
zone is within Zones 9-16. Press

ZONES 9-16

on the con-

sole to see which zone was tripped.

A motion detector causes

false

alarms

• Motion detectors sense motion by detecting a

change in temperature; therefore, do not place the
motion detector near an air conditioning or heating
vent.

• Do not place it in a direct source of bright light, such

as sunlight.

• It could be detecting a pet’s movements. Set the

switch on the back to

so it is less sensitive or

cover its bottom zones.

49-2570.fm Page 31 Wednesday, August 18, 1999 3:59 PM

This manual is related to the following products:

CENTRAL 5000