Regency FireGenie - Manual (Page 4)

FPI FireGenie TM Remote Control Manual 4
The Remote Control handset has a set of unique ID codes that is pre-programmed into its memory. This
set of ID codes helps to differentiate one Remote Control handset from another so that only the control
box with a matching ID code will respond to the appropriate Remot Control handset.
To ensure the Remote Control is matched to the Receiver correctly, please follow the steps below;
1. Ensure that the pilot is lit and the pilot control knob is in the ON position at the appliance.
2. Ensure both the Remote Control and the Receiver box are switched OFF.
3. Install the 2 x AAA alkaline batteries into the Remote Control.
4. Install the 4 x AA alkaline batteries into the Remote Receiver.
5. Switch the Receiver box to the REMOTE position.
6. Press and hold the PROG and PRESET buttons simultaneously on the remote control for up
to 20 seconds. During this time, the remote will display “LC” while it is transmitting codes to
the receiver. Once it has successfully transmitted, the burner will come on. If it does not work
the fi rst time wait for 1 minute and repeat steps 1 - 5.
7. Release both the PROG and PRESET buttons. The remote control will revert back to normal,
but the burner will still be on.
8. Press the ON/OFF button on the remote 2 times to turnn the burner off.
9. The remote control is now programmed to the receiver and the appliance can now be operated
with it.
The control box will only learn the Remote ID codes during the fi rst 30 seconds after power is ap-
plied and will ignore this special command from the Remote Control after the fi rst 30 seconds.
NOTE: This must only be performed by a qualifi ed installer.
MATCHING REMOTE CONTROL & RECEIVER ID CODE
IMPORTANT NOTE
When there is no signal from the Remote Control to the Receiver
either when the battery is low or the remote is out of range, the unit
will automatically shut down in 4 hours +/- 48 minutes.