Ryobi RY30931 - Manual (Page 20)

0
OPERATION
STARTING AND STOPPING
See Figures 21 - 23.
To start a cold engine:
DO NOT squeeze the throttle trigger until the engine starts
and runs.

Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the rope until the engine starts.
 Wait 6-10 seconds, then squeeze the trigger to run.
NOTE: Squeezing and releasing the throttle trigger releases
the start lever to the
RUN position.
To start a warm engine:
PULL the rope until the engine starts.
To stop the engine:
Press and hold the switch in the stop “ ” position until
the engine stops.
Fig.
Fig. 1
THROTTLE
TRIGGER
IGnITIOn
SwITcH
THROTTLE
TRIGGER
IGnITIOn
SwITcH
Fig. 3
PRIMER BuLB
TRIGGER
LOck
START
POSITIOn
START
LEVER
START
LEVER
Run
POSITIOn
TRIGGER
LOck