RIDGID R8452 - Manual (Page 21)

21
50 45
30
3
2
1 45
0
0
1
2
3
4
5
6
Fig. 23
LOWER BLADE
GUARD HANDLE
LOWER BLADE
GUARD
POCKET CUTTING
See Figure 23.
WARNING:
Always adjust bevel setting to zero before making
a pocket cut. Attempting a pocket cut at any other
setting can result in loss of control of the saw,
possibly causing serious injury.
Adjust the bevel setting to zero, set the blade to the correct
blade depth setting, and swing the lower blade guard up
using the lower blade guard handle.
Always raise the lower blade guard with the handle to avoid
serious injury.
While holding the lower blade guard by the handle, firmly
rest the front of the base flat against the workpiece with
the rear of the handle raised so the blade does not touch
the workpiece.
Depress the lock-off button and squeeze the switch trigger
to start the saw. Always let the blade reach full speed then
slowly lower blade into the workpiece until base is flat
against workpiece.
After you complete your cut release the trigger and allow
the blade to come to a complete stop. After the blade has
stopped, remove it from the workpiece. Corners may then
be cleared out with a hand saw or sabre saw.
WARNING:
Never tie the lower blade guard in a raised position.
Leaving the blade exposed could lead to serious
injury.
OPERATION