Ryobi 155r - Manual (Page 15)

TROUBLESHOOTING
15
C A U S E A C T I O N
Cutting attachment bound with grass Stop the unit and clean cutting attachment
Cutting attachment out of line Refill with new line
Inner reel bound up Replace the inner reel
Cutting attachment dirty Clean inner reel and outer spool
Line welded Disassemble, remove the welded section
and rewind the line
Line twisted when refilled Disassemble and rewind the line
Not enough line is exposed Push the Bump Knob and pull out line until
4 inches (102 mm.) of line is outside of the
cutting attachment
C A U S E A C T I O N
Battery is not charged Charge battery. See Charging the Unit, page 8.
Overload protection switch has popped Reset overload protection switch
MOTOR OPERATES SLOWLY OR WILL NOT OPERATE
BATTERY WILL NOT CHARGE
C A U S E A C T I O N
No power to charger or battery Check charger and charging station. See Charging
the Unit, page 8.
Battery has failed Replace battery. See Battery Pack Replacement,
page 13.
CUTTING ATTACHMENT WILL NOT ADVANCE LINE
SPECIFICATIONS
Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Volt DC, 15 Amps
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sealed Lead-Acid, 12 Volt
Motor Wire Housing Tube . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Aluminum Tube
Unit Weight (With battery, cutting attachment shield and D-handle) . . . . . . . . . . . . . . . . . . . . . . . . 10.2 lbs. (4.63 kg.)
Cutting Mechanism . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Bump Head
Line Spool Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 in (76.2 mm)
Trimming Line Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.080 in (2.03 mm.)
Cutting Path Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 in. (254 mm)
BATTERY AND MOTOR