Royal Sovereign RDH-130 - Manual (Page 10)

10
OPeRATIOn 2
Removing the collected water
1. Use the bucket
When the unit is off, if the bucket is full, the unit will beep 8 times and the Full indicator light will flash, the digital display
shows P2.
When the unit is on, if the bucket is full, the compressor turns off and the fan turns off after 30 seconds for drying the
water of the condenser, then the unit will beep 8 times and the Full indicator light will flash, the digital display shows P2.
Slowly pull out the bucket. Grip the left and right handles securely, and carefully pull out straight so water does not spill.
Do not put the bucket on the floor because the bottom of the bucket is uneven. Otherwise the bucket will fall and cause
the water to spill. (Fig.6 & 7)
Pour the water out and replace the bucket. The bucket must be in place and securely tightened for the dehumidifier to
operate. (Fig.8)
The machine will re-start when the bucket is restored in its correct position.
nOTe: When you remove the bucket, do not touch any parts inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate. When you remove the bucket, if there is some water in the
unit you must dry it .
Fig.6
Fig.7
Fig.8