RCA PRO-X55AV - Manual (Page 3)

3
3. Push down the speaker’s red tab to open
the positive (+) terminal and insert the
wire’s other conductor. Release the tab.
4. Using the speaker wire’s coding as a
guide, connect the other end of the
speaker wire to the amplifier’s
corresponding (right or left) speaker
terminals.
MAINTENANCE
To enjoy your PRO-X55AV 2-Way Die-Cast
Mini Speaker for a long time:
• Keep the speaker dry. If it gets wet, wipe
it dry immediately.
• Use and store the speaker only in
normal temperature environments.
• Handle the speaker gently and carefully.
Don’t drop it.
• Keep the speaker away from dust and
dirt.
• Wipe the speaker with a damp cloth
occasionally to keep it looking new.
Modifying or tampering with the speaker’s
internal components can cause a
malfunction and might invalidate its
warranty. This receiver has been
manufactured to the specifications of
RadioShack and is covered by a limited
warranty from RadioShack. If your receiver
is not operating as it should, take it to your
local RadioShack store or call 1-800-THE-
SHACK for assistance.
SPECIFICATIONS
Frequency Response: ........... 80–20,000 Hz
Power Handling ................ 70 Watts (RMS)
Maximum Power ........................ 140 Watts
Impedance ................... 8 Ohms (Nominal)
Speaker Complement:
5-Inch High-Compliance
Woofer and 1-Inch Extended
Range, High-Compliance
Soft Dome Tweeter
Dimensions (HWD):
8 9 /
16
Ч
5 1 /
2
Ч
4 7 /
8
Inches
(22
Ч
14
Ч
12.4 cm)
Weight ....................................... 5 lb 12 oz
(2.32 kg)
Specifications are typical; individual units
might vary. Specifications are subject to
change and improvement without notice.
40-5003.fm Page 3 Friday, August 6, 1999 8:44 AM