RCA DRC6379T - Manual (Page 16)

12
Playing a Disc
1. Slide the CHARGE / STANDBY / ON switch to the ON position. See CUSTOMIZING
THE FUNCTION SETTINGS before proceeding to step 2.
2. Pull up front panel and press DVD door to open the disc door.
3. Hold the disc by its sides and gently push it onto the spindle, with label side
facing up, until you hear a “click”.
4. Gently push the disc door closed. It takes a short while for your unit to load
the disc. After loading, for most DVDs, the unit will automatically take you
to the main menu or start playing. If the unit does not automatically start
playing the DVD, press the PLAY button.
Pausing Playback (Still Mode)
Press the PAUSE button. To resume normal playback, press the PLAY
button.
Each time you press the PAUSE button, the picture advances one frame.
Stopping Playback
Press the STOP button at the location where you want to interrupt playback. To resume playback at the
position where the disc was stopped, press the PLAY button.
If you press the STOP button twice, the unit’s memory will be cleared and pressing the PLAY button will
reset the disc to the beginning.
Fast Forward / Fast Reverse
1. Press the SEARCH or SEARCH button when a disc is playing. Each time you press the SEARCH or
SEARCH button, the playback speed changes in the following sequence:
2. Press the PLAY button when you reach the desired point to resume normal playback.
Note:
• The DVD player mutes sound and subtitles during reverse and forward scan of DVDs.
• The fast playback speed may differ depending on the disc.
Skip (Forward / Reverse)
• Press the PREV button to go back to current or previous chapters/tracks/titles.
• Press the NEXT button to advance chapters/tracks/titles.
• For audio CDs, use the number buttons on the remote control to go directly to the desired track number.
This owner’s manual explains the basic instructions
for operating this unit. Some DVDs are produced
in a manner that allows specific or limited
operation during playback. Therefore, this unit
may not respond to all operating commands. THIS
IS NOT A DEFECT. Please refer to the instructions accompanying the specific DVD in question for
more information about the options available on
that DVD.
“ ” may appear on the screen during operation.
A “ ” means that the desired operation is not
permitted by the unit or disc.
Playing a Disc