Ryobi P201 - Manual (Page 17)

16 17
OPERATION
TORQUE
ADJUSTING RING
TO DECREASE
TORQUE
TO INCREASE
TORQUE
Fig. 14
Fig. 15
MAG TRAY ™
SCREWS
TORQUE ADJUSTMENT
See Figure 14.
When using the drill-driver for various driving applications,
it becomes necessary to increase or decrease the torque
in order to help prevent the possibility of damaging screw
heads, threads, workpiece, etc. In general, torque intensity
should correspond to the screw diameter. If the torque is
too high or the screws too small, the screws may be dam-
aged or broken.
The torque is adjusted by rotating the torque adjustment
ring.
The torque is greater when the torque adjustment ring is
set on a higher setting. The torque is less when the torque
adjustment ring is set on a lower setting.
The proper setting depends on the type of material and the
size of screw you are using.
MAG TRAY ™
See Figure 15.
The Mag Tray
™ conveniently stores screws or other small
parts.
BIT STORAGE
See Figure 16.
When not in use, bits provided with the drill can be placed
in the storage areas located on the base of the drill.
BIT STORAGE
BIT(S)
Fig. 16