Rangemaster KITCHENER U109720 - 01 User Manual
Page 30
30
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
21. To Remove Oven Element.
Disconnect from electricity supply.
Remove oven inner back (see 18).
Remove 2 screws from the
top of the element and 1 from
the bottom of the element
in side the oven. Lift element
out carefully, disconnect the
terminals connected to the
element noting their positions.
If it is not possible to disconnect
the leads in this way, pull cooker
forward to gain access to the
rear.
Remove screws securing the electric cover to the back
sheet and remove cover and disconnect the terminals
from the rear.
Fit new element, and reassemble in reverse order. Check
operation of oven.
22. To change oven light bulb.
LH Oven
Remove the oven furniture and side linings. Remove the
oven rear liner.
RH Oven
Remove the oven inner back (see 18). The oven light
cover is now accessible. Unscrew the cover.
Unscrew the bulb.
Fit an Edison screw fitting 15w 240v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C.
23 To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge fixing screws and use the
notch and a flat bladed screwdriver to move the position
of the hinge to set the hinge position.
Retighten the hinge screws.
Effect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
t