Radio Shack CD-3904 - Manual (Page 12)

12 Operation
To start random play from the current
track, repeatedly press
MODE until
SHUFF appears. Random play be-
gins after the current track ends.
To cancel random play, repeatedly
press
MODE until SHUFF disappears.
USING PROGRAMMED
PLAY
You can program up to 20 tracks from
the loaded CD to play in any order
you choose (you can program the
same track to play more than once).
1. While power is on, repeatedly
press PROG . PROG flashes on
the display.
2. Repeatedly press either or
to display the number of the
first track you want to store.
3. Press PROG again to store the
selected track number and
advance to the next selection
number.
Note: If the CD is playing while
you are programming and you
press to cancel program
mode, the CD continues play.
4. Repeat Steps 2 and 3 for each
track you want to store, up to 20
tracks in all.
Note: If you try to store more
than 20 tracks in memory, the CD
player stores each consecutive
track over the first tracks stored.
5. To play the programmed
sequence, press . The first
track in the sequence plays.
While the sequence plays, you
can press
or to move
backward or forward in the
sequence.
6. After the last programmed track
ends, the CD player stops. To
stop the CD sooner, press .
You can replay the programmed se-
quence within 30 seconds after play
stops. Otherwise, the CD player turns
off and clears the programmed se-
quence.
To replay the programmed sequence,
press
PROG so PROG flashes, then
press .
To review the programmed track
numbers after programming, press
PROG repeatedly.
To clear the programmed sequence
from memory, press twice or open
the CD compartment cover.
42-6004.fm Page 12 Friday, July 21, 2000 1:18 PM