Roberts Radio CR9987 - Manual (Page 18)

Operating your radio - manual tuning
1. Switch on your radio by pressing the BAND button on the CD clock
radio or the BAND button on the remote control.
2. Select the required waveband by pressing the BAND button. The
waveband selected will appear in the display. On FM fully extend the
wire aerial from the rear of your clock radio. On MW rotate your radio
for best reception.
3. A single press on either the Tuning up or Tuning down buttons
will change the frequency up or down.
The frequency steps are:- FM 50kHz and MW 9kHz.
4. Adjust the VOLUME control to the required level.
5. The tone of your radio can be altered by adjusting the Tone control
on the right hand side of the unit.
6. Press the StandBy button to switch off your radio.
2
17
4
6
1
2
3 3
2
6
4
Remote Control
5