Roku SoundBridge Wi-Fi Music System User Manual

Page 66

Steps for using Windows Connect Now

SoundBridge Radio works with Windows Connect Now which acts as a wireless network setup
wizard to detect your network passwords and conﬁgure SoundBridge Radio to accept them.
Follow these steps to use Windows Connect Now:

1. Connect a card reader to your computer and insert an SD or MMC card. The drive letter of

the card should be noted (this can be found in My Computer).

2. Run the ‘Wireless Network Setup Wizard’ from the XP control panel and follow the

instructions. A number of ﬁles will be written to the SD or MMC card attached to the
computer via the card reader. Be sure to choose the driver letter as noted above.

3. Take the SD or MMC card out of the reader and plug that card into SoundBridge Radio.

4. Use the SoundBridge Radio remote control to scroll down to ‘Select Wi-Fi SSID and

Password’ and press Select. This detects the ﬁles on the SD card and uses the information to
conﬁgure the SSID and password.

5. Restart SoundBridge Radio.

Note: Because SoundBridge Radio doesn’t write anything back to the SD/MMC card you won’t
see SoundBridge Radio show up in the ﬁnal network list if you have followed the ‘Wireless
Network Setup Wizard’. You may have to click ‘Cancel’ on the ‘Wireless Network Setup Wizard’
because the computer expects the card to be reinserted after setup of network devices is
complete.

Multiple Wi-Fi Networks

If SoundBridge Radio detects more than one Wi-Fi network, you will be asked to select which
SSID (network name) you want to use. You will only be asked to select an SSID if you have more
than one wireless network at your location. If you have more that one network, scroll down to
select from the Wi-Fi networks you have and press

Select [ ].

You can also enter the name of a Wi-Fi network. To enter a network name, follow these steps:

1. From “Select Wi-Fi SSID and Password,” select “Specify a wireless network” and press

Select [ ].

Section 13: Appendices