Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM - Manual (Page 15)

Need help? Call 1-800-950-7044!
15
Notes:
• You must enter a zero before a single-digit
channel number (01, 02, 03, and so on).
• If you normally press ENTER after entering a
channel number to change to a new channel,
you must press
ENTER instead of SET UP .
5. Repeat Step 4 to continue entering channels you
want to include in your favorite channel scan list.
After you have entered the last channel number,
hold down
SET UP (the last time) until the red indi-
cator light blinks twice.
6. To scan through your favorite channels, press
SCAN and keep the system’s remote control
aimed at your TV. The remote control scans
through the selected channels, stopping on each
one for 3 seconds. To stop scanning, press any
key on the remote control.
Note: You can only set up the favorite channel scan
feature for one device at a time. To clear the favorite
channel list, press and hold down
SET UP until the red
indicator light blinks twice. Then press 9 9 6 SET UP
SET UP , and hold down SET UP the last time until the
red indicator light blinks twice.
Sequences
You can use AUDIO SEQ or VIDEO SEQ on your 6 in 1
RF Remote Control System’s remote control to send a
set of commands at the press of a button. Any se-
quence of commands you regularly perform can be re-
duced to a single keypress.
For example, you might want to turn on your TV and ca-
ble box, then set the cable box to Channel 3.
Follow these steps to set up that sequence.
1. Press and release TV , then press and hold down
SET UP until the red indicator light blinks twice.
2. Press 9 9 5 VIDEO SEQ .
3. Enter the desired sequence. For example:
TV PWR CBL PWR 0 3.
15-1919.fm Page 15 Monday, July 19, 1999 12:34 PM