Radio Shack 21-1703 A - Manual (Page 4)

4
Setup
Setup
Attaching the Microphone Holder
You can attach the microphone holder to either side of the transceiver or to
another location in your vehicle.
To attach the holder to either side of the transceiver, secure the holder to the
side using the supplied 3mm self-tapping screws, and spring washers.
To attach the holder to another location in the vehicle, such as the dashboard,
follow these steps.
1.
Using the holder as a template, mark the positions for the mounting screw
holes at the desired location.
2. At each marked position, drill a hole slightly smaller than the supplied
mounting screws.
3. Attach the holder at the mounting location using the supplied 3mm
machine screws, spring washers, plain washers, and nuts.
Note: If you cannot reach behind the mounting surface to attach the nuts on
the machine screws, use the supplied 3mm plain washers and self-tapping
screws.
Holder
3mm self-tapping
screw
Spring washer