Rangemaster U109100 - 02 - Manual (Page 22)

22
Setting the Water Level
Due to diff ering water pressures within the UK, the water setting level pressure will vary. There are 8 levels that
can be selected to control how much water is supplied to the Icemaker. The factory setting is Level 1.
If the size of the ice cubes produced are too small, then the following steps can be taken to increase the water
supply to the Icemaker
Measurement Picture
Picture
No.
There are 2 buttons - FRZ. TEMP and REF. TEMP
on the freezer door control panel. Press both
simultaneously for about 3 seconds, until the bell
sounds (Pic 1).
FRZ. TEMP and REF. TEMP will display "+88" (all other
symbols will be displayed as shown in Pic 2).
Release BOTH buttons, then IMMEDIATELY press
them again at the same time. After 3 seconds, the bell
sounds and all display symbols disappear (Pic 3).
Release buttons, then press them again for 3
seconds. The bell sounds and a number is displayed
in the REF. TEMP position (Pic 4).
Release the 2 buttons.
Press the "ICE/WATER OPTION button and select the
level desired - the higher the number, the more water
supplied to the Ice-maker.
The adjustable level range is from 1 to 8 (Pic 5).
Finally, press the "FRZ. TEMP" and "REF. TEMP"
buttons simultaneously, until the display returns to
1
2
3
4
5
6