Ryobi SS180 - Manual (Page 12)

12
OPERATION
USING CIRCLE CUTTER
See Figure 10.
Follow these directions when using the circle cutter.
■ Assemble circle cutter if necessary. Refer to “AS-
SEMBLING CIRCLE CUTTER” earlier in this manual.
■ Attach circle cutter to Speed Saw if necessary. Refer
to “ATTACHING CIRCLE CUTTER” earlier in this
manual.
■ Adjust depth of cut if necessary. Refer to “ADJUST-
ING DEPTH OF CUT” earlier in this manual.
■ Loosen pivot point knob.
■ Move pivot point knob to desired diameter dimen-
sion.
■ Tighten pivot point knob.
■ Start Speed Saw.
■ Cut a pilot hole in the center of the intended circle.
■ Line up pivot point knob with the lead
hole.
■ Begin cut, applying moderate, steady pressure.
■ Hold the Speed Saw firmly with one hand and the
handle with the other.
CAUTION:
Too much force causes heat build up, which can
shorten the life of the bit.
■ Work in a clockwise direction, continuing back to the
starting position.
■ Stop Speed Saw.
Fig. 10