Reel Mowers, Etc MM-1 - Manual (Page 5)

Owner’s Manual — Sunlawn MM-1
3
2. Fit the lower section of the handle so that the holes are over the
handle posts on the mower. Then rock the handle to align the locking
tabs and allow the handle section to fit into place.
3. Continue assembly of the middle and top sections of the handle
using the handle bolts and wing nuts.
ADJUSTING THE CUTTING HEIGHT
The cutting height of the MM-1 may be adjusted from approximately
1/2 inch up to approximately 2 1/4 inches. Actual height may vary
according to the height of the turf. Adjust the mower to the desired
height as follows:
1. Loosen the two large black knobs, one on each side of the mower
body, to allow movement of the roller arms. NOTE: the handle is
mounted to the roller arms and thus moves with the arms.
OPERATION
Bottom Handle Mount Hole
Top / Middle Handle Mount Hole