Integrated amplifier – Roksan Audio LIII User Manual
Page 10

Roksan Audio ltd
Kandy Integrated Amplifier User Manual
CLASSIFICATION: General Use
Version 3.3
All specifications are liable to change without notice. E&OE
Page 10 of 11
ENGLISH
There are no user-serviceable parts inside your Kandy Integrated Amplifier. If a fault should develop, refer any servicing to
your appointed ROKSAN dealer, distributor or ROKSAN approved service agent.
Your ROKSAN Kandy Integrated Amplifier is guaranteed against any defect in materials and workmanship for a period of two
years from the date of purchase.
This guarantee only becomes effective if the warranty card is validated by the ROKSAN retailer from whom the equipment
was purchased and returned to ROKSAN within 28 days of purchase.
This guarantee excludes:
1. Damage caused due to accident, missuse, neglect and incorrect installation, adjustment or repair.
2. Liability for damage or loss during transit from the retailer or purchaser to ROKSAN or its authorised distributor for the
purposes of repair or inspection.
Carriage costs to ROKSAN shall be borne by the consignor.
All claims under this guarantee must be made through an authorised ROKSAN retailer.
If equipment returned for repair to ROKSAN is found on inspection to comply with the product specification ROKSAN
reserves the right to make a charge for examination and return carriage.
Unauthorised servicing will void this guarantee.
Inputs
Line Level (x5), Moving Magnet (x1), Tape (x1)
Input Impedance
47 k
Ω
Input
Sensitivity
(115W) Line
470mV
Outputs
Speaker L & R (x1), Preamplifier (x2), Tape (x1), Headphone (x1)
Output Power
>120 Watts, into 8
Ω
both channels driven
>185 Watts, into 4
Ω
both channels driven
Power Supply
500VA Ultra Low Noise Toroidal Transformer
4 Regulated Supply Rails
Damping Factor >110
(8
Ω)
Frequency response
(-3dB), <3Hz – >100kHz
Gain
38dB Overall (Pre & Power)
7dB Preamplifier
31dB Power Amplifier
Harmonic Distortion
<0.005% 1kHz - 8
Ω
Signal to Noise Ratio
Line 100dBa (ref 470mV)
Power Source
100V – 120V 50Hz / 60Hz
220V – 240V 50Hz / 60Hz
Power Consumption
Standby <25W, Full Power 2-CH 8
Ω < 330 W, 4Ω <550W
Dimension
432 x 380 x 90 (W x D x H) mm
432 x 380 x 102 (including feet)
Weight
14 Kg
G U A R A N T E E
K a n d y
Integrated Amplifier
S P E C I F I C A T I O N S
K a n d y
Integrated Amplifier