Rayburn Cookmaster Plus 212SFW - Manual

Installation Instructions for
Rayburn Cookmaster 200SFW
and Rayburn Cookmaster
Plus 212SFW Solid Fuel Cooker
REMEMBER, when replacing a part on this
appliance, use only spare parts that you can be
assured conform to the safety and performance
specification that we require. Do not use
reconditioned or copy parts that have not been
authorised by AGA.
The Rayburn Cookmaster 200SFW is intended to be
used for cooking only. The Rayburn Cookmaster Plus
212SFW is intended to supply heating for cooking and
domestic hot water.
The Rayburn Cookmaster 200SFW has been tested
using Taybrite manufactured smokeless fuel only. The
nominal heat output of this appliance is 4.4 kW.
The Rayburn Cookmaster Plus 212SFW has been
tested using Taybrite manufactured smokeless fuel and
wood logs. The nominal heat output of this appliance is
6 kW. This provides about 2 kW to hot water and 4 kW
to the appliance. Other fuels may give a slightly
different result.
Weight of Rayburn Cookmaster Plus 212SFW - 300 Kgs.
Weight of Rayburn Cookmaster 200SFW - 240 Kgs.
There is no requirement for an electrical power supply.
The mean flue gas temperature of the Rayburn
Cookmaster 200SFW directly downstream of the flue
spigot at nominal heat output is 131ºC.
The mean flue gas temperature of the Rayburn
Cookmaster Plus 212SFW directly downstream of the
flue spigot at nominal heat output is 210ºC.
PERFORMANCE
1 08/06 EINS 514406 [email protected]
Consumer Protection
As responsible manufacturers we take care to make sure that our
products are designed and constructed to meet the required safety
standard when properly installed and used.
IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING
WARRANTY. Any alteration that is not approved by Aga could
invalidate the approval of the appliance, operation of the warranty
and could affect your statutory rights.
All local regulations including those referring to National and
European standards need to be complied with when installing
the appliance.
Important
This appliance may contain some of the materials that are
indicated. It is the Users/Installers responsibility to ensure that the
necessary personal protective clothing is worn when handling,
where applicable, the pertinent parts that contain any of the listed
materials that could be interpreted as being injurious to health and
safety, see below for information.
Firebricks, Fuel beds, Artificial Fuels - when handling use
disposable gloves.
Fire Cement - when handling use disposable gloves.
Glues and Sealants - exercise caution - if these are still in liquid
form use face mask and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Kerosene/Gas Oil -
may be harmful if inhaled, may be irritating to skin, eyes, nose and
throat. When handling avoid inhaling and contact with skin or
eyes. Use disposable gloves, face-masks and eye protection.
After handling wash hands and other exposed parts. When
disposing of the product, reduce dust with water spray, ensure that
parts are securely wrapped.
WARNING
THE ASHPIT DOOR AND FIREBOX DOORS MUST
BE LOCKED CLOSED AT ALL TIMES DURING
NORMAL USE, EXCEPT WHEN LIGHTING OR RE-
FUELLING
DESN 510179 D
Better than you ever imagined