ROWENTA REF. 3460984 - Manual (Page 11)

11
STEAM 'N PRESS TROUBLE SHOOTING
Problem Possible Cause Solution
Leaking or Distilled water. Never use 100% distilled water.
spitting. The Steam 'n Press is designed to
use tap water. In very hard water
areas we recommend using
bottled spring water.
Softened water. If you experience spitting or
leaking with softened water,
change to untreated tap water
or bottled spring water.
Thermostat set The thermostat needs to be set
incorrectly. to the 3 dot setting to produce
steam.
Overuse of burst Allow 4 seconds between each
of steam. burst.
Water tank. Be sure that water tank is firmly
in place.
Isn't hot enough. Allow Steam 'n Press to heat for
approximately 1 minute before
using.
Steam 'n Is it plugged in? Check plug securely in socket.
Press won't
heat.
Is thermostat set Turn the thermostat to a higher
too low? setting.
Does not Is water in the Ensure tank has water in it.
steam. tank?
Burst button not Press the burst button 4-5 times
primed. to begin steaming.
Not enough Dual voltage not Be sure the dual voltage selector
power or set correctly. is in correct voltage position
too much before operating. Unplug the
appliance and turn the selector
(which is below the handle) with
a coin to align it with the correct
voltage (either 120 or 240 V).