Ryobi ESR2400A - Manual (Page 8)

English
- 7 -
After use, unplug the shredder and clean it inside and out.
All un-painted metal parts should be greased to prevent
rusting.
When closing the shredder take care to remove all dirt and
debris from the thread of the hole of the securing knob for
the cover.
If the cover is not closed properly, the shredder will not start.
Take care not to cross-thread the bolt when the cover is
being bolted down.
If shredding is not coming out of the chute, stop and unplug
the shredder, remove the lid and clear the chute.
CARE & MAINTENANCE
If the machine is overloaded, an overload protection
switch will cut the shredder off-leave it for about 5
minutes and try again it should then start. (See Fig. 6)
Place the collecting bag, a bucket or small bin under the
chute to collect the shredding in.
Do not put your hand inside the hopper, when necessory
use the plunger.
Do not try to force branches in that are too large for the
machine.
The blades tend to pull the branches into the shredder
but finer material such as leaves may need to be pushed
through with the plunger.