Radio Shack 12-888 - Manual (Page 2)

You can use headphones (not supplied) to listen to
your radio privately. Insert the headphone’s plug into
the jack on the side of your radio.
Listening Safely
Follow these guidelines when you use headphones.
• Set volume to its lowest level before listening. After
you begin listening, adjust volume to a comfortable
listening level.
• Do not listen at extremely high volume levels.
Extended high-volume listening can lead to
permanent hearing loss.
• Once you set the volume, do not increase it. Over
time, your ears adapt to the volume, so a volume
level that does not cause discomfort might still
damage your hearing.
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Product: Digital AM/FM/WX Radio
Model: 12-888
Responsible Party: RadioShack
100 Throckmorton
Fort Worth, TX 76102
Phone: 817-415-3200
The FCC Wants You to Know
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV
technician for help.
If you cannot eliminate the interference, the FCC requires that you
stop using your radio. Changes or modifi cations not expressly
approved by RadioShack may cause interference and void the
user’s authority to operate the equipment.
This product is warranted by RadioShack against manufacturing defects in material
and workmanship under normal use for ninety (90) days from the date of purchase
from RadioShack company-owned stores and authorized RadioShack franchisees
and dealers. For complete warranty details and exclusions, check with your local
RadioShack store.
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04
©2004. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
12-888
09A04
Printed in China
Frequency range:
AM ............................................................ 530 to 1710Khz
FM ......................................................... 87.5 to 108.1MHz
Weather (Wx) ....................................162.4 to 162.55 MHz
Power supply: ............................................120V AC 60Hz
DC6V (4 C size batteries)
Headphone: ............................................ 3.5mm diameter
Speaker max. output: .......................250mW per channel
1. Turn on your radio. The display lights blue if
you are using AC power. The display lights for
a few seconds if using battery power.
2. Extend the antenna and adjust for best
reception.
3. Press BAND to select AM or FM or WX band.
4. Rotate VOLUME to a comfortable listening level.
5. Rotate TUNER/SEEK to tune to a radio station. Or,
hold down TUNER/SEEK until a beep sounds to
automatically search for stations (AM/FM only).
STEREO appears on the display when you tune to
an FM station broadcasting in stereo.
6. Rotate VOLUME counterclockwise until it clicks to
turn off the radio.
presetting stations
1. Turn on your radio.
2. Press BAND to select AM or FM band.
3. Tune to the desired station.
4. Hold down MEMORY SET until a beep sounds. A
number (1-10) fl ashes on the display.
5. Press a STATION PRESET button to save the station
in that location.
6. Press MEMORY SET. A beep sounds to confi rm. If
no button is pressed within 15 seconds of the
beep, the station will not be stored.
6. To listen to preset stations, press the
corresponding STATION PRESET button.