Rosen Entertainment Systems viocecom 1000 - Manual (Page 9)

VoiceCom 1000™ Interactive Voice Control
speaker-dependent, so in general the system will only recognize the voice of the
speaker, who has programmed the phonebook of the VoiceCom 1000™
system. When the system responds with the name you entered, i.e. "JOHN,"
you say "Dial" and the system responds with "THE NUMBER IS DIALED," and the
connection will be made. In case the system does not recognize your name
command it will respond with "ENTRY NOT FOUND," and you should repeat
the name entry. If the name is still not recognized, it may not be stored in the
phonebook. Would you like to confirm the name again before the corresponding
number is dialed, say, "Repeat" and the system will repeat the name, i.e.
"JOHN." Saying "Cancel" will end the dialing procedure and the system
responds with "CANCEL." When speaking "Dial Name" and the system
responds with "NETWORK IS NOT AVAILABLE", your mobile phone has not
locked on to the network of your service provider. Wait for a moment and retry. If
the system continues repeating the message "NETWORK IS NOT AVAILABLE,"
you might be outside the coverage area of your network service provider.
"Store Name"
DO NOT ATTEMPT TO PERFORM THE FOLLOWING
PROCEDURE WHILE DRIVING THE CAR! STOP THE CAR
AND THE ENGINE AND PARK IN A SECURE PLACE
BEFORE ENTERING INTO THE VOICE CONTROL
PROGRAMMING DIALOG!
In order to use the "Dial Name" procedure, you need to store names and the
corresponding phone numbers into the phone-directory of the VoiceCom 1000™
system, which accepts up to 30 entries and is independent of the directory of
your mobile phone. You begin the storing process by saying "Store Name", and
the system will respond with "THE NAME PLEASE". Now clearly speak the
name, e.g. "John". The system will ask, "PLEASE REPEAT THE NAME", and you
need to say the name again. Should you pronounce the name differently from
the first time you said it, the system responds with "INPUT IS TOO
DIFFERENT" and you have to repeat the name as said originally. When the
system has accepted the name it will prompt you with "THE NUMBER
PLEASE", and you enter the number the same way as described in the
command "Dial Number" above. The system will acknowledge the number and
you must say "Store", and the system responds with "THE NAME IS STORED".
If you try to enter a name and number, which you have already entered
previously, the system will inform you with the phrase "THE NUMBER IS
ALREADY STORED", that this entry already exists after you have said the name
twice. Should all 30 phone-directory places already be used up, the system will
-9-