Radio Shack 16-3313 - Manual (Page 11)

Ot
he
r C
o
n
nec
ti
ons
11
• When you stop playing a disc, the DVD player
remembers where you stopped.
• When you press PLAY g to start playing the disc
again, the player picks up where you left off unless
you press STOP
D again, removed the disc, or
unplugged the DVD player.
9. To turn off the DVD player, press POWER on the DVD
player. The DVD player’s POWER indicator turns off.
Removing a Disc
To remove a disc, use your thumb to hold down the spindle
while placing other fingers on the recess at the upper right
and lifting up the edge of the disc.
OTHER CONNECTIONS
You can connect your DVD player to a TV, a TV and Audio/
Video receiver, a camcorder, a game system console, or a
digital camera.
C ONNECTING TO A TV
Position cables properly to avoid audio
interference.
• Insert each cable firmly into the
designated jack.
• If you place components above the TV,
route all cables down the side of the
back of the TV instead of straight
down the middle of the back of the TV.
• If your antenna uses 300-ohm twin
lead cables, do not coil the cables.
Also, keep the twin lead cables away
from audio/video cables.
1. Connect the supplied A/V cable’s two-
plug end to the OUTPUT VIDEO / AUDIO
jacks on the back of the DVD player.
The yellow plug is
VIDEO . Black is
AUDIO .
2. Connect the supplied A/V cable’s
three-plug end to an A/V cable (not
supplied) connected to your TV. Match
the cable by color code if possible.