beautypg.com

Troubleshooting bar and chain combinations – Ryobi RY10518 User Manual

Page 38

background image

Page 38 — English

Problem

Possible Cause

Solution

Engine will not
start. [Make sure
ignition switch is in
the

RUN ( l ) posi-

tion.]

No spark.


Engine is flooded.


Clean or replace spark plug. Reset spark plug gap. Refer
to

Spark Plug Replacement earlier in this manual.

With the ignition switch

OFF, remove spark plug. Move

choke lever to

RUN position (pushed in completely) and

pull starter cord 15 to 20 times. This will clear excess
fuel from engine. Clean and reinstall spark plug. Set igni-
tion switch to

RUN ( l ) position. Push and fully release

primer bulb 7 times. Pull starter three times with choke
lever at

RUN. If engine does not start, move choke lever

to

FULL CHOKE and repeat normal starting procedure.

If engine still fails to start, repeat procedure with a new
spark plug.

Engine starts but
will not accelerate
properly.

Carburetor requires

“L” (Low Jet)

adjustment.

Contact an authorized service center for carburetor
adjustment.

Engine starts, then
dies.

Carburetor requires

“L” (Low Jet)

adjustment.

Contact an authorized service center for carburetor
adjustment.

Engine starts but
will not run proper-
ly at high speed.

Carburetor requires

“H” (High Jet)

adjustment.

Contact an authorized service center for carburetor
adjustment.

Engine does not
reach full speed
and/or emits ex-
cessive smoke.

Lubricant/fuel
mixture incorrect.

Air filter is dirty.


Spark arrestor
screen is dirty.


Carburetor requires

“H” (High Jet)

adjustment.

Use fresh fuel and the correct 2-cycle lubricant mix
ratio.

Clean air filter. Refer to

Cleaning the Air Filter in the

Maintenance section of this manual.

Clean spark arrestor screen. Refer to

Inspecting/Clean-

ing the Spark Arrestor Screen in the Maintenance sec-

tion of this manual.

Contact an authorized service center for carburetor
adjustment.

Chain specifications: 0.0325 pitch, .05 in. chain gauge

Length of Bar

Guide Bar Part Number

Chain Part Number

Drive Links

20 in.

310629001

900920027

78 link

18 in.

310628001

901430001

72 link

TROUBLESHOOTING

BAR AND CHAIN COMBINATIONS

This manual is related to the following products: