beautypg.com

The ovens, The clock – Rangemaster CLASSIC 110 GAS FSD User Manual

Page 8

background image

8

The Ovens

The clock must be set to the time of day before the

ovens will work. See ‘The Clock’ section of these

instructions for how to set the clock.
Before using for the first time, heat the ovens to Mark

7 for 30 minutes to dispel manufacturing odours.

Open a window to clear the smell.

1

Push in and turn the knob controlling the oven to Gas

Mark 9. The oven will light automatically.

2

Turn the control knob back to the temperature you

wish to cook on and for best results pre-heat for 15

minutes before placing your dishes in the oven.

3

The ovens use our special ‘Heatflow’ system.
Because the oven burner is not hidden under the

oven base you will see the burner flames at the back

of the oven - this is perfectly normal.
The oven is protected by a safety cut off, which

reduces the supply of gas to the oven if the flames go

out, e.g. an interruption to the mains supply.

Initially the gas will burn with a small flame but after

approximately one minute the flame will become

larger indicating that the oven is full on.

4

Dishes cooking on the central shelf will cook at the

gas mark indicated on the knob.

5

Dishes placed above the central position will be

cooked at approx. one gas Mark higher, dishes

cooked below approx. one gas Mark lower. You can

therefore cook dishes requiring different gas Marks at

the same time.

6

The ‘S’ setting is a very low temperature for slow

cooking, overnight or while you are out or at work.

The ‘S’ setting can also be used for keeping food

warm.

The Clock

You can use the timer to turn the ovens on and off.

The clock must be set to the time of day before the

ovens will work.

To set the time of day

Press and hold as shown.

At the same time, press (-)

or (+) until the correct time

shows.
Don’t forget it’s a 24 hour

clock.

If you make a mistake or press the wrong button, turn

off the power supply for a minute or two and start

again.If the key symbol ( ) appears on the left of the

display you have accidentally turned on the key lock

feature. See the section ‘Clock Special Features’.