Rikaline, Software interface, 1 nmea transmitted messages – Rikaline E-705 User Manual
Page 10
Rikaline
Rikaline Marketing Corp.
5F-1, 125, Roosevelt Road, Sec. 5, Taipei, Taiwan 116
Tel: ++886 2 2934 5456 Fax: ++886 2 2934 4373 E-Mail:
web:
www.rikaline.com.tw
10
5. Software Interface
The E-705 interface protocol is based on the National Marine Electronics Association's NMEA 0183 ASC
Ⅱ
interface specification, which is defined in NMEA 0183, Version 2.2.
5.1 NMEA Transmitted Messages
The E-705 outputs data in NMEA-0183 format as defined by the National Marine Electronics Association
(NMEA), Standard.
The default communication parameters for NMEA output are 4800 baud, 8 data bits, stop bit, and no parity.
Table 5-1 NMEA-0183 Output Messages
NMEA Record
Description
GPGGA
Global positioning system fixed data
GPGSV
GNSS satellites in view
GPRMC
Recommended minimum specific GNSS data
GPVTG
Course over ground and ground speed
5.1.1 Global Positioning System Fix Data (GGA)
Out put time, position and position – fix related data.
Table 5-2 contains the values for the following example:
$GPGGA,161229.487,3723.2475,N,12158.3416,W,1,07,1.0,9.0,M, , , ,0000*18
Table 5-2 GGA Data Format
Name
Example Units
Description
Message ID
$GPGGA
GGA protocol header
UTC Time
161229.487
Hhmmss.sss
Latitude 3723.2475
ddmm.mmmm
N/S Indicator
N
N=north or S=south
Longitude 12158.3416
dddmm.mmmm
E/W Indicator
W
E=east or W=west
Position Fix Indicator
1
See Table 5-3
Satellites Used
07
Range 0 to 12
HDOP
1.0
Horizontal Dilution of Precision
MSL Altitude
9.0
Meters
Units of Altitude
M
Meters
Geoid Separation
Meters
Units M
Meters
Age of Diff. Corr.
second
Null fields when DGPS is not used
Diff. Ref. Station ID
0000
Checksum *18
End of message termination
Table 5-3 Position Fix Indicator
Value Description
0
0 Fix not available or invalid
1
GPS SPS Mode, fix valid
2
Differential GPS, SPS Mode, fix valid
3
GPS PPS Mode, fix valid
Note: the NMEA checksum consists of a “*” and two hex digits representing exclusive-OR of all the
characters between, but not including, the “$” and “*” characters