Radio Shack HTX-200 - Manual (Page 39)

39
TURNING THE KEY TONE ON AND OFF
The transceiver is preset to sound a beep each time you press a
key. To turn off the beep, press
FUNC + ( BEEP) . disappears.
To restore the key tone, press FUNC + ( BEEP ) again.
Note: If the key tone feature is disabled, the power-on tone does
not sound.
CHECKING THE CURRENT MEMORY
SETTINGS
If you hold down MO ( REV ) for longer than 1 second, the squelch
opens and the set values for receive tone ( rT on / off ), transmit
tone ( tt on / off ), scan skip condition ( SCSP )(if any), repeater
offset ( rPt ), and frequency step ( CS ) appear.
Release MO ( REV ) to turn on the squelch again.
SETTING THE FREQUENCY STEP
To change the frequency increment used during scanning and
stepping to a frequency, use the Main Menu to access the CS op-
tion setting (see “Using the HTX-200’s Menus” on Page 16). Then
repeatedly press
or until you reach the desired setting. You
can change the frequency step to 5 kHz, 10 kHz, 12.5 kHz, 15
kHz, 20 kHz, 25 kHz, 50 kHz, or 1 MHz. (The example shown
here is 25 kHz.)
19-1102RPO.fm Page 39 Friday, June 25, 1999 11:17 AM