Royal Sovereign RHD-2201 - Manual (Page 6)

6
Detail for the operation panel
Power : It starts after pushing button, and it is set temperature 90ºC and speed
6step(75mic+80g) when the start.
Please push the power button when shut off. It is set the temperature
60ºC and speed 2step automatically, then it is stop automatically after for
a while.
HOT : After pushing Cold function and Stand By function then pushing HOT
button that is set up the temperature 90ºC and speed 6 step automatically.
Please control the temperature and speed on it’s requred film specification
referring to the manual “Film Termperature and Speed chart”
Cold : Please push the cold button when the lamination of cold film.
Temp : It can be controled 40ºC ~ 160ºC in unit of 1ºC
In case of wide range of temperature, please push the button
continuously.
Speed : It can be controled 1~9 step in units of 1step
(Please refer to the manual “Film Termperarure and Speed Chart”)
Start lamp : When not ready, light on and off repeatably
When ready, the lamp light on
Reverse : In case of wrong inserting and rolled film, the machine has a reverse
function
Stand By : It is set up the temperature 80ºC and speed 2step automatically.
(please use this function when you stop the machine for a while)
T-Check : In case of changing temperature and starting the machine, the present
temperature of roller can be checked.
RHD-2201
Temperature window Ready lamp Speed window
Temperature control button
Temperature check button
Speed control button
Cold lamination button
Reverse button Power On/Off
Stand By Button
Hot lamination button