Radio Shack LIFEWISE 63-1515 User Manual

Wrist cuff blood pressure monitor, Step three, Step four step two what’s included

Step Three

Install Batteries

1. Remove the battery compartment cover.

2. Insert two AAA batteries as indicated by

the polarity symbols. For easy removal,
place the ribbon under both batteries.

3. Replace the cover.

When the display dims or batteries weaken,
Áappears on the display. Replace the batter-
ies.

Attaching the Pressure Cuff

1. With your palm face up, wrap the pressure cuff snugly around

your wrist, leaving about

inches to

inches (0.5 to 1 cm)

clearance between the wrist and the cuff.

2. Place your elbow on the table and wrist against the armrest or

the storage case so the pressure cuff is at the same height as
your heart.

Wrist Cuff Blood
Pressure Monitor

63-1515

Setting the Date and Time

1. Press

MODE

. The month digit flashes.

2. Repeatedly press (or hold down)

SET

to set

the correct month.

3. Repeat Steps 1 and 2 to set the date, hour,

and minute. Press

MODE

when finished.

Measuring Blood Pressure

1. Press

START/STOP

. All display segments

appear briefly, the systolic rate rests to

and

Â appears. The pressure cuff

automatically inflates to 195 mmHg or the
sufficient pressure level for measurement.
The systolic rate varies, and

♥

flashes at

the same rate as your heartbeat.

2. Once the monitor detects your blood

pressure reading, the pressure cuff deflates
slowly. Your blood pressure reading and
pulse rate appear.

3. To stop measurement, press

START/STOP

Ã appears for about five seconds when:

•

The pressure cuff is not wrapped around your wrist
correctly.

•

You move or talk during measurement.

•

You do not have correct posture.

Step Four

Step Two

What’s Included

•

Wrist Cuff

•

Monitor

Recalling Stored Readings

1. Press

RECALL

. The last reading with the

date and time appears.

2. Repeatedly press (or hold down)

RECALL

to view other stored readings (up to 48).

3. To view current date and time, repeatedly

press or hold down

RECALL

until the current

date and time appear.

4. To erase all stored readings, remove and

reinstall the batteries.

Step Five

•

Storage Case

Step One