Redring 500S - Manual (Page 10)

10
5. Re-Fit the front cover (see diagram 9)
a. Ensure knob “A” is aligned to the “High” position.
b. Ensure knob “C” is aligned to “12 o’clock.
c. In the main body of the shower, turn the
“Camshaft” as shown.
d. In the main body of the shower, turn the “Numbered Dial” fully clockwise until it is at the position
shown. Note:- this instruction should be used if the “Drive Dial” becomes accidentally dislodged.
e. Fit the front cover of the shower to the main body.
Ensuring that the knobs correctly engaged to their mating component.
f. Check that knob “A” has been correctly aligned by ensuring that all 3 power settings can be selected.
g. Check that knob “C” has been correctly aligned by turning anti-clockwise and ensuring that knob turns
approximately 1 full turn and when turned back fully clockwise, returns to “12 o’clock”.
1
6. Replace the top and bottom fastening screws.
7. Fit the shower hose, and operate the shower first without the handset to flush out particles,
fit the handset and then operate the shower as on page 3 or 12 and check:
a. That the water gets to a satisfactory temperature.
b. Water flow can be adjusted by control knob “C”.
c. Power selection operates in all 3 positions, giving a change in water temperature and that the power
indictor lights functions correctly.
d. Check again for leaks
e. That the holes in the shower handset are not blocked
8. DEMONSTRATE OPERATION TO USER