Technical data, Installation, Closing the door – AEG ELECTROLUX AGS 1921 User Manual
Page 78: Location

Problem
Possible cause
Solution
dEMo appears on the Dis-
play.
The appliance is in demonstra-
tion mode (dEMo).
Keep pressed approximately 10
sec. the OKbutton since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height
1600 mm
Width
600 mm
Depth
630 mm
Rising Time
35 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Location
The appliance should be installed well away from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To
ensure best performance, if the appliance is positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet and the wall unit must be at least 100
mm . Ideally, however, the appliance should not be positioned below overhanging wall
units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabi-
net.
If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance
between the wall and the cabinet must be at least 10 mm to allow the door to open
enough so that the shelves can be removed.
78
Technical data