Ryobi BGH615 - Manual (Page 11)

Page 11
ASSEMBLY
WARNING:
Always disconnect the bench grinder from the power
source before performing any assembly or adjustment.
Failure to do so could result in accidental starting result-
ing in possible serious personal injury.
SPARK DEFLECTOR – BGH615
See Figure 4a.
Using two 6 mm hex bolts and washers, attach the spark
deflector to the inside of the wheel guard.
Adjust the spark deflectors to within 1/16 in. of the grinding
wheel. Tighten the hex bolts securely.
SPARK DEFLECTOR – BGH625 AND BGH825
See Figures 4b and 4c.
Using the two phillips head screws, washers, and lock
washers, attach the spark deflector to the top of the wheel
guard.
Adjust the spark deflectors to within 1/16 in. of the grinding
wheel. Tighten the hex bolts securely.
WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn’t hit the
grinding wheel.
WARNING:
Always make sure your bench grinder is securely mounted
to a workbench or an approved workstand. Failure to do
so could result in an accident resulting in possible seri-
ous personal injury.
Fig. 4c
WASHER
HEX BOLT
SPARK
DEFLECTOR
BGH615
BGH625
BGH825
Fig. 4b
Fig. 4a
SPARK DEFLECTOR
LOCK
WASHER
SCREW
SPARK DEFLECTOR
LOCK
WASHER
SCREW
WASHER
WASHER