Ryobi Router Table A25RT02 - Manual (Page 12)

12
ASSEMBLY
PRE-DRILLING HOLES FOR THROUGH
TABLE DEPTH ADJUSTMENT
See Figure 8.
Since each router will have different placements for through
table depth adjustments, pilot holes have been pre-drilled in
the throat plate to assist in through table adjustments. Only
the models listed below in the key are available for use with
the through table depth adjustment feature.

Remove the throat plate.
 Determine which router you have and find the pre-drilled
pilot hole that matches your router. (Refer to the key be-
low.)
 Using a drill and drill bit, drill a hole through the pilot hole
large enough for the depth adjustment tool (not included
with router table, but may be included with your router)
to pass though so through table depth adjustments can
be made.
Figure 8 Key:
RD: RIDGID R2930
RY: Ryobi R163K
ML: Milwaukee 5615-20, 5616-20
PC1: Porter-Cable 890 Series
PC2: Porter-Cable 8529
ATTACHING THE ROUTER TO THE TABLE
For ease of use, assemble the router to the insert plate with
the insert plate removed first, then install the insert plate/
router assembly into the router table.
ATTACHING THE ROUTER TO THE INSERT
PLATE
See Figures 9 - 10.

Remove the insert plate.
 Remove the subbase plate from the router.
 Using the following chart for reference, and using one of
the three included sets of three router insert plate screws,
attach the router to the insert plate with the pilot holes
facing the router and the notch in the insert plate facing
the back of the router table.
NOTE: When attaching insert plate to the router, make
sure the holes in the router base match up with the insert
plate accurately and are not off-center.
INSTALLING THE ROUTER/INSERT PLATE
ASSEMBLY
See Figure 11.

With the insert plate installed on the router, insert router
and insert plate assembly into the router table with the
notch in the insert plate facing the back of the router table
toward the fence assembly.
 Install the insert plate screws and leave loose until all
adjustments have been made.
Inch
1
0
1
2
3
Inch
1
0
1
2
3
FEED DIRECTION
Fig. 10
Fig. 11
NOTCH
A1
A3
A5
A6
A4
B3
B4 A2
B2
B1
RD
PC2
RY
PC1
PC1
ML
Fig. 8
Fig. 9
PRE-DRILLED
PILOT HOLES
INSERT PLATE
REAR SIDE
INSERT PLATE
FRONT SIDE
INSERT PLATE
ROUTER INSERT
PLATE SCREWS
INSERT PLATE
SCREWS
NOTCH