RedMax LRT2300 - Manual (Page 14)

Operation
• This product is equipped with extremely
sharp blades, and when used
improperly these blades can be
extremely dangerous, and improper
handling can cause accidents which
may in turn lead to serious injury or
death. For this reason, you should
always be careful to follow the following
instructions when using your trimmer.
• Never hold the trimmer in a way in which
the blades are pointed towards someone
else.
• Never allow the blades to come into
proximity with your body while the engine
of the trimmer is in operation.
• Always be sure to turn off the engine
before changing the angle of the blades,
removing branches which have become
stuck in the blades, or at any other time
when coming into close proximity with the
blades.
• Always wear work gloves made of leather
or some other sturdy material when using
the trimmer.
• Always place the blade cover provided
with the trimmer over the blades when
not in use.
• Falling branches may fall onto the face
or into the eyes, resulting in injuries,
scratches, and cuts, and for this reason
you should always be sure to wear a
helmet and face protector when using
your trimmer.
The thickness of branches which may be cut
using this trimmer is limited to up to
approximately 3/16". Never try to cut
branches thicker than this, as doing so may
result in damage to the trimmer.
NOTE
WARNING
■ Adjusting the angle of the cutting blades
1. Stop the trimmer engine.
2. Turn the bolt located on the top of the
trimming mechanism counter-clockwise
to loosen it.
3. Adjust the angle of the blades to the
desired angle, and then fix the bolt
firmly back into place.
❲ 12 ❳