R & M Int'l. CGC-1e - Manual (Page 10)

Page 10
MAINTENANCE / SPECIFICATIONS
SPECIFICATIONS:
System operating voltage
120vac +/- 20% @ 50-60 Hertz
Maximum Switching amperage 15-amps @ 120vac
Overload protection 15-amp normal blow fuse
Operating temperature 0 - 50’ C / 32 - 122’ F
Maximum humidity 95% RH (Non-condensing)
Temperature control range 50-115’ F with a 7’ F differential, +/- 3.6’
Humidity control range 20 - 80% RH with a 5% differential
Adjustable timer repeatability +/- .2% under fixed conditions
Timer setting accuracy +/- 5%
Hydro “ON” timer 1 second to 40 minutes
Hydro “OFF” timer 1 minute to 8 hours
CO2 Inject duration timer 1 second to 40 minutes
CO2 Inject frequency timer 1 minute to 8 hours
24-hour timeclock accuracy +/- 3% monthly
Dimensions 10” X 8” X 7”
Weight Less than 6 lbs.
Relay operations Minimum 100,000 electrical / 10,000,000 mechanical
MAINTENANCE:
1) Consult the troubleshooting chart for a listing of the most common problems.
2) DO NOT open the enclosure!!! There are no components that require maintenance.
3) Do not use this equipment for purposes other than what it is designed for. It will provide many years of trouble-free
service when used properly.
4) In the event you cannot solve the problem, first consult the dealer who sold the unit then contact the factory for
instructions on how to return it to the factory for repair.
PUBLISHED BY R & M Supply INC.
COPYRIGHT 2008 BY R & M Supply
ALL RIGHTS RESERVED.
Liability statement:
R & M Supply and their retailers and distributors are not responsible for any damage or injuries (consequential or otherwise)
arising from the use of this device. The purchaser assumes all responsibility for the use and proper installation of this device.