Reebok Fitness weight bench RBBE0787.2 - Manual (Page 7)

7
2. Orient the Bench Frame (1) as shown. Orient the
Front Stabilizer (2) with the square holes in the
location shown.
Press two Stabilizer Caps (9) onto the Front
Stabilizer (2). Attach the Front Stabilizer to the
Bench Frame (1) with two M10 x 90mm Carriage
Bolts (15) and two M10 Nylon Locknuts (13).
Do
not tighten the Nylon Locknuts yet.
2
1
13
13
9
15
Square Hole
Square Hole
3. Orient the Rear Stabilizer (3) with the warning
decal on the indicated side. Press two Stabilizer
Caps (9) onto the Rear Stabilizer.
Attach the Rear Stabilizer (3) to the Bench Frame
(1) with two M10 x 90mm Carriage Bolts (15) and
two M10 Nylon Locknuts (13).
Do not tighten the
Nylon Locknuts yet.
Make sure the Bench Frame (1) and the Front
and Rear Stabilizers (2, 3) are level with the floor.
See steps 2 and 3. Tighten the M10 Nylon
Locknuts (13) used in step 2 and 3.
3
1
9
9
13
15
13
Warning
Decal
3
2
9
4. Attach the Seat Frame (4) to the Bench Frame
(1) with the four indicated M10 x 75mm Button
Bolts (16) and four M10 Nylon Locknuts (13).
Note: It will be necessary to tip the weight
bench on its side to tighten the Nylon
Locknuts.
4 13
16
1
4