Roberts Radio TCR-200 - Manual (Page 9)

9
2. Press RECORD . Both RECORD and
PLAY lock down. When RECORD is
pressed down, every call made or
received is recorded.
Notes:
• If you set REC MODE to VOX ,
when both parties are silent for
about 5 seconds, the recorder
stops recording until someone
starts speaking again.
• The VOLUME setting does not
affect the recording level.
• VU/LEVEL flashes during record-
ing.
• To temporarily stop recording,
press PAUSE . To resume record-
ing, press PAUSE again.
• If the tape reaches the end during
a recording, it automatically
releases
RECORD and PLAY , and
stops.
3. To stop recording, press STOP/
EJECT .
Setting the Record Mode
When REC MODE is set to VOX , the re-
corder begins recording when it receives
sound through the microphone or phone
line, and stops recording when it does
not receive sound for about 5 seconds.
Set REC MODE to NORM to record con-
tinuously until the tape reaches the end
or you press
STOP/EJECT .
Setting the Sensitivity Level
When you set REC MODE to VOX , you
must set the sensitivity level located on
the bottom of the recorder.
H (high) is
the most sensitive setting and requires
only a soft sound to begin recording.
L
(low) is the least sensitive setting and
requires a louder sound to begin record-
ing. If the tape does not stop after about
5 seconds of silence, set
SENSITIVITY to
M (medium) or L (low).
TCR-200 VOICE ACTIVATED
TELEPHONE CASSETTE RECORDER
MIC
VU
LEVEL
0 0 0
PLAY RECORD STOP/EJECT
CUE REVIEW
FAST-F REWIND PAUSE
STD EXT OFF ON
DC 6V 300mA
VOX NORM
REC MODE MONITOR SPEED
SENSITIVITY
L M H
CAUTION
ALWAYS DISCONNECT ALL TELEPHONE
LINES FROM THE WALL OUTLETS BEFORE
SERVICING OR DISASSEMBLING THIS
EQUIPMENT, OR REPLACING BATTERIES.
43-473.fm Page 9 Friday, August 13, 1999 9:21 AM